Set Inner + Exterior Door Handle Bowl Cover Trim For Honda Civic 10th 2016-2021 Xotic Tech Factory Store

This listing features on 1 Set(12 pieces) of Premium quality ABS interior Side Door Handle Bowl + Exterior Epoxy Resin 3D REFLECTIVE CARBON FIBER Door Handle Cover trim specially For Honda Civic 10th Gen

【SAFETY】High reflective performance, warning other drivers beside your car, make your beloved car much safer in the dark night.

【SPECIFIC】Different from vinyl sticker type, our product is made of high-quality new tech epoxy resin with certain thickness, soft and comfortable, exquisite workmanship, unparalleled abrasion resistance and cushioning performance.

【FUNCTION】This reflective sticker can effectively protect the door handle and door bowl, prevent scratches and collision, protect the paint, will not change the appearance of your dear car.

【EASY INSTALL】Convenient to install, clean the location, tear off the protective film on the back of the product, adjust the position and press down to complete the operation. With strong adhesion, it can be used for a long last time without leaving traces and will not damage the surface paint of the car.

【Compatibility】Compatible with Honda Civic Sedan 10th Gen 2016 2017 2018 2019 2020 2021(Won’t fit Hatchback Models)

Fitment

• For Honda Civic Sedan 10th Gen 2016 2017 2018 2019 2020 2021(Won’t fit Hatchback Models)
• Please ensure the part of your car like our picture shows

Description

• Condition: 100% Brand New
• Interior Door Handle Bowl Trim Material: Premium quality ABS plastic
• Exterior Door Handle Trim Material: Epoxy Resin Glue (NOT VINYL STICKER)
• Size: 1.Exterior Door Handle Bowl Sticker：3.5″ x 3.35″ / 2.Exterior Door Handle Strip：5.1” x 0.4”
• Upgrade the appearance of your car
• Waterproof and never fade, wear-resisting & scratch-resistant
• Protects the door handle from scrapes, nail scratches and sand, grease, salt
• Protect the installed area from scratches and dirty
• Easy installation, simply peel and stick on
• Surface must be clean and dry prior to adhering

Installation

• Please clean the place where you want to installed it, use rubbing alcohol first. (make sure to remove the dirty,like grease, wax or dust)
• To check the installation area according to the vehicle with this product first and then release the back of tape paper (double-sided tape, a label) is removed
• Products are equipped on the vehicle with exactly and use a clean cloth to press evenly is attached.In the case of a relatively low temperature, heat installation location, and plate with a hair dryer on low setting
• Put the product in desired location carefully and press down for about 1-2 minutes, The adhesive should be cured after 12-hours
• Products within 24 hours after installed, please avoid washing your car and touching the water.

Note

• Compatible of vehicles are only for reference, cause the same car model may be differently produced in different country.  Please ensure the part of your car like our picture shows, or it will not fit, if any differences, please contact with us before purchase, thanks!